Boiler spraying

The wear of the pipe wall is closely related to the concentration of solid materials in the airflow, the velocity of the flue gas, the characteristic hardness of the particles, and the geometry of the flow path. According to relevant research data, the amount of scouring wear is approximately proportional to the 3.6th power of the airflow velocity.HORIZONTAL MITRE BAND SAW MACHINE BS-1018R In CFB boilers, the concentration of solid materials is huge, usually up to dozens to hundreds of times that of pulverized coal boilers, and the flue gas flow rate is large, the particles are hard and sharp-edged, so driven by the high-speed flue gas, the CFB boiler The erosion and wear of the heating surface such as the water cooling wall is extremely serious.HORIZONTAL SCISSOR STRUCTURE MITER METAL BAND SAW MACHINE CS-280S Especially at the water wall at the top of the retaining wall, because it is located at the edge of the dense phase zone, it is not only strongly scoured and worn by the high-speed and high-concentration bed material and fuel airflow, but also has serious eddy current effect, cutting effect and centrifugal effect.Aluminum alloy micro-channel cooling plate vacuum gas quenching The eddy current effect is at the four corners of the furnace. Because the side wall flow is formed here, more materials gather here. Due to the inertia of solid particles, the local wear is particularly obvious, and the cutting effect is reflected in the water wall at the root of the retaining wall. The reason is that Since the top of the protective wall provides a platform.Martensitic stainless steel quenching vacuum heat treatment process